. Water soluble

. Salt & alcohol free

. Non Irritating

. Reduce Wrinkles with Facial Massager

. Spreads evenly without running or drying

Why use a Conductive Gel with Facial Massager?

A gel is needed to conduct the ultrasound waves deep into the skin. Research shows that the transmission pro portion of ultrasonic waves in the air is 0%, about 50% in general water, 60% in distilled water, near 70% in glue matter, and above 70% in special conductive gel.

Besides, another positive effect of ultrasonic wave is the promotion of skin absorbing nutrition. A gel enhances the transmission of ultrasonic waves into your skin.

For best results, apply conducting gel to the area to be treated (they must be certified by hygiene organization). Do NOT apply oily cream when using ultrasonic waves. 

How to use the Fyola Facial massager?

1. Apply suitable amount of gel ( a circle with 2 cm diameter) on the treatment head

2. Switch the power ON

3. Choose the right mode

- Cleansing
- Massasing
- Nutrition
- Lifting
- Whitening
- Wrinkle Care

4. Select Ultrasonic, Galvanic Ion or Both

Select ultrasonic wave mode to remove waste inside your skin or galvanic ion mode to enhance the absorption of ingredients (Vitamin C) into your skin.

When ultrasonic and galvanic ion mode are used at the same time, the permission through the out skin layer will be 77 times better than using the ultrasonic mode or gavalnic mode seperately.

5. Move the facial head around your face

Move the treatment head of the facial massager in circle following the formation of the muscles. See illustrations for the directions. Do not stop moving the treatment head in use, about the rate of 5 centimeters within 1 second. The power would shut off automatically.

6. Wash your face

After using the facial massager, clean your skin with water or tissue papers

7. Clean the Facial Massager

Clean the treatment head with tissue papers after use